- Mots-clés > GMP inspectors and manufacturers
- Mots-clés > good engineering practices (GEP)
- Mots-clés > Good Manufacturing Practices (GMP)
- Mots-clés > inspection of pharmaceutical products - standard operating procedures
- Mots-clés > quality assurance
- Mots-clés > Standards Operating Procedures (SOP)
- Mots-clés > validation - manufacturing process
- Mots-clés > validation and qualification
- Mots-clés > validation, water, air handling systems
- Mots-clés > WHO expert committee
(2015; 12 pages)
Further to the Supplementary guidelines on good manufacturing practices: validation, as published in the World Health Organization (WHO) Technical Report Series, No. 937, additional guidelines to support current approaches to good manufacturing practices (GMP) are published here. These guidelines are intended to further support the concept of process validation linked to quality risk management (QRM) and quality by design principles as described by WHO and the International Conference on Harmonisation of Technical Requirements for Registration of Pharmaceuticals for Human Use (ICH).
These guidelines allow for different approaches to process validation. The principles described are mainly applicable to non-sterile finished pharmaceutical dosage forms. Similar approaches may be applicable to active pharmaceutical ingredients (APIs) and sterile products. (See also recommendations in WHO Technical Report Series, No. 957, Annex 2 and WHO Technical Report Series, No. 961, Annex 6.)
A risk-based and life-cycle approach to validation is recommended.
Thorough knowledge of product and process development studies; previous manufacturing experience; and QRM principles are essential in all approaches to process validation, as the focus is now on the life-cycle approach. The life-cycle approach links product and process development, validation of the commercial manufacturing process and maintaining the process in a state of control during routine commercial production.
The use of process analytical technology (PAT), which may include in-line, online and/or at-line controls and monitoring, is recommended to ensure that a process is in a state of control during manufacture.